- This topic has 0 replies, 1 voice, and was last updated 15 years, 6 months ago by
.
-
Posts
-
Hi guys , i just realised i posted in the wrong zone so here goes.
I upgraded to 1.60.In page mode and when working on 1 track or more i cant get step attributes to control Position of track.I use to use this loads and since the upgrade its not functioning as it was ? I just want to set a step to automate a position change of a track say 1 step at a time or shift a track forward relative to others 1 step at a time each time the step attribute is hit. . .cant figure this one out at all since 1.60 upgrade . it seems to hit the step , shift position once and then freeze there rather than keep shifiting the position each time the track cycles.Any help would be appreciated or an explanation of whats changed .
best wishes
matt
Post edited by: mattishq, at: 2008/10/19 12:32
Post edited by: admin, at: 2009/03/14 04:37
Post edited by: admin, at: 2009/03/14 04:46
- You must be logged in to reply to this topic.