Edit perform state

OS_CE Forums Nemo User exchange Edit perform state

This topic contains 2 replies, has 2 voices, and was last updated by  Philip Clinckspoor 7 years, 11 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #1086

    Philip Clinckspoor
    Participant

    I can’t get this to work. The manual says: in page mode, the edit led is normally lit green: true. When you click it once it blinks orange: true. When clicking it again after that, it should blink green indicating the edit perform mode is active. When I try this, the edit led turns to its initial "lit green" state again, instead of blinking green.

    #2863

    Roderick van Erp
    Participant

    Do you have OS 1.62 on your Nemo…?
    Edit : I saw in another post that you are running OS1.60….so that means no Edit perform.

    Are you in page mode…?

    Is the sequence stopped when trying to switch…?

    Post edited by: Prime NL, at: 2010/07/27 15:54

    #2864

    Philip Clinckspoor
    Participant

    ok, that solves my question. thanks

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.